You can change your cutter to a smaller diameter on-tool or you can change the cut type from a pocket cut to an inside cut If a ledge is narrower than the cutter installed, then the pocketing protective boundary tool paths will not be produced. Shoulders and narrow ledges don't produce tool paths on Origin: The Shaper logo will display in the top tool bar (see below). If the plugin fails to install, follow these steps:ġ: Uninstall Fusion 360 if it was downloaded from the Apple StoreĢ: Reset Apple home permissions following the instructions found hereģ: Download and install Fusion 360 from the Autodesk web site hereĤ: Download and install the Shaper Add-In from the Autodesk app store hereĥ: Go to Modeling mode in Fusion 360.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |